Code Alarm CA650 Bedienungsanleitung PDF herunterladen (Seite 19)

2 Pin Valet/Program/Override Push-Button Switch: (Blue Connector)

The BLACK & BLACK/WHITE twin lead wires loaded in the two pin blue connector are the ground supply

and program/valet/override input of the Remote Start unit. Drill a 9/32" hole and mount this switch in an

easily accessible location under the driver's dashboard.

4 Pin Antenna/Receiver Connector: (Black Connector)

Mount the supplied antenna/receiver to a clear spot on the vehicle's windshield that will not block the

driver's vision. A good location is usually high on the windshield near the rear view mirror. Be careful not

to mount the antenna/receiver on any metallic window film, as this will effect system range. Route the

antenna/receiver cable to the control module and plug in to the 4 pin black connector.

2 Pin LED Harness: (White Connector)

The Red & Blue wires loaded into the two pin mini white connector control the anode and cathode of the

dash mounted LED. Drill a 1/4" hole and mount the LED in an easy to see location on the dashboard.

Be careful to check to make sure that there is enough clearence behind the panel you are drilling into.

4 Pin Data Bus Interface Port: (Brown Connector)

This 4 pin port is used for Code Alarm Door Lock and Transponder Databus Interfaces to communicate

with the vehicle's Databus. When using the DBI port to control the Code Alarm Door Lock and

Transponder Interface modules the following options may be available. Please refer to the D2D (Data to

Data) function list available per vehicle on the tech service web site.

Tach Input Brake Safety Shut Down

Door Trigger Trunk/Hatch Open

Door Lock Control Passlock / Passkey Interface (GM Only)

Dome Light Supervision Transponder Interface Activation

Factory Alarm Arm / Disarm Manual Arm / Disarm Inputs (factory keyless controls system)

Diesel Glow Plug Input

6. ACCESSORY CONNECTORS

1 2 ... 14 15 16 17 18 19 20 21

Keine Kommentare

Code Alarm CA650 Bedienungsanleitung Seite 19