Code Alarm CA650 Bedienungsanleitung PDF herunterladen (Seite 14)

5. DOOR LOCKS

Negative Lock Output / Positive Unlock Output (GREEN)

Negative Unlock Output / Positive Lock Output (BLUE)

Negative Second Door Unlock Output (LT. GREEN/BLACK Must be changed in programming)

Positive Switching and Positive Switching with 2-step unlock feature:

All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock switch.

Verification: These wires will register positive voltage when the Lock and Unlock switches are activated.

Driver’s Door Unlock: Locate the unlock motor wire directly from the actuator inside the driver’s door.

Verification: This wire will rest at ground and register positive voltage when the driver’s door is unlocked.

Connect the GREEN and BLUE or LT. GREEN/BLACK wires shown in diagram 8 below.

Note: When adding the 2 step unlock feature the LT. GREEN/BLACK 2nd door unlock wire will be used to

unlock all vehicle doors on the second press of unlock. Two additional SPDT relays (not supplied) are

required. Connect the relays as shown in diagram 9 to unlock the driver’s door on the first press of

unlock.

Diagram 9

Lock

Unlock

Door Lock S witch

Vehicle Door Lock

C ontrol R elays

BLUE (+) Lock Output

87a

LT. GREEN/BLACK 2nd

Door Unlock Output

Fused +12 Volt

Battery Source

Diagram 8

GR E E N (+) Unlock Output

87a

To Unlock Side Of

Driver's Door Actuator

F us ed +12 Volt

Battery Source

From Keyless E ntry

Module Or Door

Lock/Unlock Relays

CUT

Chassis Ground

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Keine Kommentare

Code Alarm CA650 Bedienungsanleitung Seite 14