Code Alarm CA680 Bedienungsanleitung PDF herunterladen (Seite 10)

(+)

(-)

ositive Polarity Outp

(+)

(-)

egative Polarity Outp

2. BASIC INSTALLATION - 22 PIN BASE HARNESS

Starter Input (Key Side) (GREEN) / Starter Output (Motor Side) (PURPLE)

Locate the vehicle starter wire.

Verification: This wire registers voltage only when the key is turned to the START position. Cut the vehicle's

starter wire in half.

Verification after starter wire is cut:

• KEY SIDE of starter wire registers voltage when the key is turned to the START position.

• MOTOR SIDE of starter wire registers no voltage.

Connect the GREEN wire to the KEY SIDE of the vehicle starter wire at the ignition switch harness.

Connect the PURPLE wire to the MOTOR SIDE of the vehicle starter wire.

Dome Light Supervision Output (+/-) (BLACK/WHITE)

Locate the vehicle’s dome light or pin switch wire.

Verification: This wire will register positive voltage or ground when the vehicle's dome light is turned ON.

To select Negative or Positive polarity output refer to Fuse Placement Diagram below:

1. 4 PIN MAIN POWER HARNESS, CONTINUED

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Keine Kommentare

Code Alarm CA680 Bedienungsanleitung Seite 10