Code Alarm CA 110 Bedienungsanleitung PDF herunterladen (Seite 7)

128-6832

7 of 16

Select By Operating Transmitter Press Btn 1 Press Btn 2 Press Btns1&2

Siren Indications 1 Chirp 2 Chirps 3 Chirps

1) Arming Method Passive Arm Active Arm

2) Ignition Control Lock/Unlock Off On

3) Passive Or Active Door Locks Active Passive

4) Single Or Double Pulse U/L Single Pulse Double Pulse

5) Door Lock/Unlock Pulse Duration 1 Second 3 Seconds

6) Siren Chirps On/Off On Off

7) Horn Chirps On/Off On Off

8) Passive Rearm From Active State On Off

9) Anti Hi-Jack Feature Off On

10) Horn Chirp Duration 10ms 16ms 30ms

Defalut settings are in BOLD

Programmable Features

The keychain transmitter included with the system have been pre-programmed at the factory, with each

button pre-assigned to control a specific function of the system.

It is important to remember that during programming, each individual step of the procedure must be

executed within 15 seconds of the previous step.

When the 15 second time limit is allowed to expire, the system will automatically terminate the

programming mode. This is indicated by a long chirp from the siren.

Additionally, the system will store codes from up to 4 different

transmitters. If a 5

transmitter is programmed to any receiver channel, then the first transmitter

programmed to that channel will be erased from the system’s memory.

To program new or additional transmitters, the alarm must be disarmed:

1. Enter the vehicle, and turn the ignition key to the ON position.

2. Press and release override/pushbutton 3 times.

3. The dash LED will flash one time, and the sounding device will beep one time, indication the system is

ready to accept programming for receiver channel 1.

4. Press and hold the Arm/Disarm Icon button until the sounding device emits a long beep, indicating the

signal has been stored into memory.

5. If you have additional transmitters (up to 4) that need to be programmed, repeat step 4 for each transmitter.

PROGRAMMING THE TRANSMITTERS

1 2 3 4 5 6 7 8 9

Keine Kommentare

Code Alarm CA 110 Bedienungsanleitung Seite 7