Code Alarm CA 110 Bedienungsanleitung PDF herunterladen (Seite 4)

128-6832

4 of 16

Grey: (-) Instant Trigger Zone 2

This is an Instant ground trigger wire. It must be connected to the previously installed hood and/or

trunk pin switches.

Green: Negative Door Trigger Input

If the vehicle’s courtesy light switches have a (-) ground output when the door is opened (GM and

most Imports), you must connect the Green wire to the negative output from one of the door switches.

WARNING:

Do not use the green wire if the vehicle has +12 volt output type door switches. (see Purple Wire).

Violet: Positive Door Trigger Input

If the vehicle’s door courtesy light switches have a +12 volt output when the door is opened (most

Ford and some Imports), you must connect the Violet wire to the positive output from one of the door

switches. In most cases, the Violet wire will only needs to be connected to one door switch, no matter

how many doors the vehicle has.

WARNING:

Do not use the Violet wire if the vehicle has ground output type door switches. (see Green Wire)

Pink: (+) 12 VDC Ignition Source

Connect this wire to the ignition wire from the ignition switch. This wire will show +12 volts when the

ignition key is turned to the to the ON, RUN and START positions, and will have 0 volts when the key

is turned to the OFF and ACCESSORY positions.

2 Pin White Connector: Dash Mounted LED

Route the red and blue wires in the 2 pin white connector from the LED to the control module, and

plug it into the mating white connector on the side of the module.

2 Pin Red Connector: Valet/Programming/Override Switch

Route the 2 pin red connector from the override switch previously mounted to the mating two pin

connector on the module.

4 Pin White Connector: IRS-Shock Sensor Harness

Route the 4 pin connector from the previously installed shock sensor to the mating 4 pin connector of

the module.

1 2 3 4 5 6 7 8 9

Keine Kommentare

Code Alarm CA 110 Bedienungsanleitung Seite 4