Code Alarm ca5553sst Bedienungsanleitung PDF herunterladen (Seite 7)

BLUE/BLACK

START STATUS

I ACTIVE

OUTPUT

(-)

This wire provides a ground output when the remote start function is activated

and remains until 4 seconds after the remote start is shutdown.

If this wire

will

be used for multiple application's a

1 amp diode is required in-line with the stripe

facing the control module.

PURPLE!WHITE

TACH

INPUT

Locate the vehicle's ignition coil or fuel injector in the engine compartment.

Verification:

Test using the following

procedure:

Set voltmeter to AC

VOLTS.

Attach positive lead of a volt meter to a constant 12-volt source.

3. Attach negative lead of a

volt meter to the wire to be tested.

4. Start the engine.

Have someone press on the gas pedal slightly as you monitor the meter. If

connected to the correct wire, the voltage reading

will

increase as the engine's

RPM increases.

Connect the PURPLE/WHITE wire to the negative side of the vehicle ignition

coil

fuel

injector.

GRAY

HOOD PIN INPUT

(-)

Install

a Hood Pin Switch and connect to the GRAY wire. This connection is

required for Remote Start.

Verification:

This wire when connected

will

vehicle's hood is opened.

Connect the GRAY wire to the hood pin.

NOTE:

Be sure to

loom

the wire, and seal the grommet.

BROWN/RED BRAKE INPUT

(

Locate the vehicle's brake light wire at the brake pedal mounted switch. This

connection is required for Remote Start.

Verification:

This wire registers positive voltage when the brake pedal is

pressed.

Connect the BROWN/RED wire to the vehicle's brake light wire.

2012 Audiovox Electronics Corporation.

All

rights reserved.

1 2 3 4 5 6 7 8 9 10 11 12 ... 48 49

Kommentare zu diesen Handbüchern

Keine Kommentare

Code Alarm ca5553sst Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto Alarmanlage Code Alarm ca5553sst