Code Alarm 1000SX Installationsanleitung PDF herunterladen (Seite 22)



4.6 Console Port Wiring

A RS232 console port for configuration and management of the device is located on the LED

display module shown in Figure 22. This port is intended to be a temporary connection during

initial configuration or troubleshooting and allows for direct access to the serial-based management

console. The connection is made using the DB9-Female to RJ45 console cable included in the

device packaging shown in Figure 23. Console connection settings are: 57600 baud, no parity

bits, 8 data bits, and 1 stop bit.

Figure 22: Console port location on display board Figure 23: RSG200 Console cable

For user reference, the console cable pin-out is show in Table 5.

RuggedCom RS232 over RJ45 pin-out specification

Signal Name (PC is DTE)

DB9

Female

RJ45 Male

DCD

–

Carrier detect

RxD

–

Receive data (to DTE)

TxD

–

Transmit data (from DTE)

DTR

–

Data terminal ready

Signal GND

DSR

–

Data set ready

RTS

–

Ready to send

CTS

–

Clear to send

–

Ring Indicator

Table 4: RS232 over RJ45 console cable pin-out

After initial configuration, the RuggedSwitch device can be configured via a number of new

mechanisms such as Telnet, and the built-in web server. Consult the RuggedSwitch ROS User

Guide for further details.

NOTE: This port is not intended to be a permanent connection and the cable shall be less than 2m

(6.5 ft) in length.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 34 35

Kommentare zu diesen Handbüchern

Keine Kommentare

Code Alarm 1000SX Installationsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto Alarmanlage Code Alarm 1000SX